To disconnect band from clasp, press in end of spring bar (use pin or small paper clip) and separate link band from clasp.
INSTRUCTION BOOKLETS NMX 15 DIGITAL YACHTIMER INSTRUCTIONS SIZING INSTRUCTIONS
To reassemble band to clasp, place spring bar in band and place end of spring into desired hole in clasp.
ELAPSED TIME RING
STEP 1: Find the tiny arrows that are engraved on the inside of the bracelet.
There are approximately 4 removable links on either side of the clasp.
The tiny arrows indicate in which direction the pins will come out.
STEP 2: Line up the needle of the disk tool with the pin hole on the bracelet.
Disk tool should be laying flat on a stable hard surface.
Insert the needle of the disk tool into the pin hole the direction indicated by the arrows.
Using your thumbs, press the bracelet down firmly onto the disk tool until pin is pushed out.
Remove protruding pin
STEP 3: Determine the number of links to be removed
If more than 1, links must be taken from both sides of the clasp.
STEP 4: To re-connect the bracelet , match-up the bracelet ends
Re-insert the pin “closed” end first in the opposite direction of the arrows.
Push the pin back into place using a hard surface
If your watch is equipped with a rotatable outer dial with numbers and indicators, this Elapsed Time Ring may be used to indicate the length of time remaining for an activity or the starting time of an activity.
TIME REMAINING – set the outer ring so that the triangle is pointing to the time the activity is to end.
STARTING TIME – set the triangle on the time the activity is to begin.
SCREW-IN SETTING CROWN
If your watch has INDIGLO on the dial, your watch is equipped with the INDIGLO Night-Light. To activate this feature, depress the crown or the pusher on the left side of the watch to illuminate the entire dial for easy reading during nighttime or low light conditions. Light will appear immediately.
Your NAUTICA watch featuring INDIGLO Night-Light contains a patented electroluminescent technology (U.S. Patent Number 4,527,96 and 4,775,964). The INDIGLO Night-Light illuminates the entire watch lens with a uniform bright light that offers superior readability in all low light and nighttime conditions. Simply press the appropriate button to activate.
WARNING: DO NOT PRESS THE BUTTON UNDER WATER AS THE WATCH WILL NOT RETAIN WATER RESISTANCE.?INDIGLO is a registered trademark of Indiglo Corporation.
Some deep-depth water-resistant analog watches require the setting crown to be screwed in to ensure water-resistance. If your watch-case has a protrusion with screw threads, the crown must be screwed in after setting the watch.
To screw in, push the crown firmly against the threaded protrusion and hold it in while turning the crown clockwise. Continue to screw in the crown light until it is tight.
If your watch is water-resistant, it will be indicated on the watch face or on the case-back.
50 Meter Water-Resistant watch withstands water pressure to 86p.s.i.a. (equals immersion to 164 feet or 50 meters below sea level) and dust as long as crystal, crown and case remain intact.
100 Meter Water-Resistant watch withstands water pressure to 160p.s.i.a. (equals immersion to 328 feet or 100 meters below sea level) and dust as long as crystal, crown and case remain intact.
NOTE: CROWN MUST BE SCREWED INTO THE CASE PROTRUSION TO ASSURE WATER RESISTANCE.